Maintenance And Storage - BWT COSMY 100 Bedienungsanleitung

Maintenance and Storage

Product Marketing Name(PMN): AQ11091W1
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference that may be received or that may
cause undesired operation. A distance of at least 20 cm. between the equipment and all persons should be maintained during the operation of the equipment.
Cleaning the filters
The two filters must be cleaned after each cleaning cycle. Press the buton to
release the filter and pull it out of the cleaner. Open the filter case. Spray water
on the outer sides of the filter and then spray water towards the inner side of the
filter to clean all the dirt and debris. Reinsert the filter back into its location.
Storing the robotic cleaner
Follow these instructions to store the robotic cleaner when not in use:
Disconnect the power cord from the wall outlet. Disconnect the floating cable
from the power supply. Make sure that the power supply is not exposed to water
Spread out the floating cable, and roll it. Wash the cleaner unit interior space
with fresh water and let it dry. Roll the floating cable and place it on the cleaner
unit. Caution: Do not roll the floating cable on the handle of the cleaner unit.
Store the robotic cleaner components in a dry, closed location.
Checking water outlet propeller
It is recommended to periodically clean debris and hair from the propeller of the
water outlet: Remove the filters. Remove the screws that hold the water outlet
cover. Remove the water outlet cover. Clean any hairs, dirt, or debris. Return
the cover and fasten it with the screw. Reinsert the filters.
COSMY THE BOT | 100 | 150 | 200 | 250 | ROBOTIC POOL CLEANERS
5