Power Supply; Cleaning Cycle - BWT COSMY 100 Bedienungsanleitung

Operation
Starting the robotic cleaner
Connect the power supply to the wall socket. The on/off button will lit and the robotic cleaner will
start its cleaning program. If the power supply is already connected to the wall socket, the on/off
button will flash to indicate that the robotic cleaner is in standby mode. Press the On/Off button
in order to change the above mode (On to Off – standby, or vice versa). Note: if the full filter
indication light is ON make sure to remove and clean the filter prior to putting the cleaner inside
the pool water.

Cleaning cycle

During the cleaning cycle, the cleaner: (1) moves across the pool floor picking up dirt and debris.
(2) Changes direction and rotates automatically according to the selected program. (3) Climbs
the pool walls every few minutes, as set in its internal program. Note: The robotic cleaner might
occasionally stop moving for a few seconds. This is part of normal operation, not a malfunction.
Stopping robotic cleaner operation
The robotic cleaner moves automatically to 'standby' after every cleaning cycle and the on/off
button starts flashing. To stop the cleaner operation during a cleaning cycle, press the operation
button once. On/off button starts flashing and the cleaner is in standby mode.
Pulling cleaner unit out of the water
(1) Unplug the floating cable from the power supply. (2) Pull the floating cable until the unit is
close enough to reach the handle. (3) Using the handle, lift the cleaner out of the pool.
CAUTION: Do not use the floating cable to lift the cleaner out of the water.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference that may be received or that may
cause undesired operation. A distance of at least 20 cm. between the equipment and all persons should be maintained during the
operation of the equipment.
4
COSMY THE BOT | 100 | 150 | 200 | 250 | ROBOTIC POOL CLEANERS

Power Supply

On/Off
Full filter
indicator
Bluetooth
On/Off
Full filter
indicator
Short cycle
Bluetooth
Delay
operation
On/Off