Maintenance And Storage - BWT Imperial Bedienungsanleitung

Maintenance and Storage

Always disconnect the power cord from the power supply before
maintenance, cleaning, or storage.
Cleaning the filters
The filter must be cleaned after each cleaning cycle: Press the button
on the front of the cleaner body, open the filter door and remove the
filter. Disassemble the filter. First spray both filters with water from the
outside and then from the inside to wash out any dirt. Verify that the
plastic flap at the bottom of the outer filter is in place and undamaged,
then reassemble the filter, replace it, and close the door until it locks into
place.
Storing the robotic cleaner
Follow these instructions to store the robotic cleaner when not in
use: Disconnect the power cord from the wall outlet. Disconnect the
floating cable from the power supply. Make sure that the power supply
is not exposed to water Spread out the floating cable, and roll it. Wash
the cleaner unit interior space with fresh water and let it dry. Roll the
floating cable and place it on the cleaner unit. Store the robotic cleaner
components in a dry, closed location.
Checking water outlet propeller
It is recommended to periodically clean debris and hair from the
propeller of the water outlet: Remove the filters. Turn the lock that holds
the water outlet cover. Remove the water outlet cover. Clean any hairs,
dirt, or debris. Check that the propeller is not damaged. Rinse with
water. Replace the cover and secure by turning the lock. Reinsert the
filters.
23
IMPERIAL ROBOTIC POOL CLEANER