Music Playback; Music Control - fontastic Paso Bedienungsanleitung

GB
1. Switch on the Speaker. The voice prompt sounds, indicating that the
speaker is in pairing mode.
2. Search for Bluetooth audio devices with your Bluetooth
®
device from which audio data is to be played.
3. The searching Bluetooth device indicates that it has the speaker
®
„Paso" has been found. Confirm the pairing with „Paso".
A successful connection is confirmed by the voice announcement.
When using a Bluetooth device without a display, switch it to
®
pairing mode and wait a few seconds. Wait for seconds until the
connection with the speaker is established.
Note: If the connection is lost or the transmitter is disconnected
for a short time, the Paso automatically tries to re-establish the
connection.
TWS function
With the TWS function, you can connect two Paso speakers together to
output your music through two speakers.
To connect two Paso, turn on both devices. Press the mode button
one of the speakers two times. The two devices connect to each other.
An acoustic signal indicates a successful connection.
Press the mode button
M
mode.
11
®
one of the speakers two times to exit this

Music playback

Play music via Bluetooth
A Bluetooth source must be paired with Paso to receive and output
®
music wirelessly!
Note: The phone must support A2DP and AVRCP profile to play and
control music through the Paso.

Music control

Play or pause music, briefly press the Play/Pause button
Skip to the next track, press and hold the Next Title button
one second.
Skip to the previous track, press and hold the Previous Track button
for one second.
Playback from Micro SD card
1. Place a Micro SD card in the card slot (7) of the Paso with the
contacts facing up.
2. The card mode will start automatically and the music will be played.
M Press the mode button
and card mode.
Note: You need to insert a Micro SD card to change the mode.
When the speaker is turned on, it will automatically start in BT
mode.
for two seconds to switch between BT
M
GB
.
for
12