Periods Of Non-Operation; Defrosting Of The Refrigerator; Troubleshooting - Zanussi ZBA15041SV Benutzerinformation

CAUTION!
When moving the cabinet, lift it by
the front edge to avoid scratching
the floor.
The equipment has to be cleaned regularly:
1. Clean the inside and accessories with
lukewarm water and some neutral soap.
2. Regularly check the door seals and wipe
clean to ensure they are clean and free from
debris.
3. Rinse and dry thoroughly.
4. If accessible, clean the condenser and the
compressor at the back of the appliance
with a brush.
This operation will improve the performance
of the appliance and save electricity
consumption.

Defrosting of the refrigerator

Frost is automatically eliminated from the
evaporator of the refrigerator compartment
every time the motor compressor stops, during
normal use. The defrost water drains out
through a trough into a special container at the
back of the appliance, over the motor
compressor, where it evaporates.
It is important to periodically clean the defrost
water drain hole in the middle of the refrigerator

Troubleshooting

WARNING!
Refer to Safety chapters.
What to do if...
Problem
The appliance does not operate.
The appliance is noisy.
The lamp does not work.
16
compartment channel to prevent the water
overflowing and dripping onto the food inside.

Periods of non-operation

When the appliance is not in use for long
periods, take the following precautions:
1. Disconnect the appliance from electricity
2. Remove all food.
3. Clean the appliance and all accessories.
4. Leave the door/doors open to prevent
Possible cause
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
There is no voltage in the mains
socket.
The appliance is not supported
properly.
The lamp is in stand-by.
supply.
unpleasant smells.
WARNING!
If you want to keep the appliance
switched on, ask somebody to
check it once in a while to prevent
the food inside from spoiling in case
of a power failure.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical ap-
pliance to the mains socket. Con-
tact a qualified electrician.
Check if the appliance stands
stable.
Close and open the door.
Solution
www.zanussi.com