Battery Charge - CANGAROO EMBRACE S19 Gebrauchsanweisung

Type
Suction Power
Stimulation Power
Charging time
Usage time
Display:
Method of control:
1.Before first time use charge the battery completely.
2.The breast pump is with a built-in battery 3.7V/ 1500 mAh.
3.Charging:
-Connect the adapter to the charging jack of the pumping mechanism.
-Insert the plug into electrical outlet of the mains supply of your home.
-We recommend you to leave the breast pump to charge completely before next use in order to prolong its battery
life.
4.Use only the charger provided with the breast pump. Do not use chargers from other products.
5.Charge the battery on time. Charge as soon as the battery indicator is with 1 bar or the indicator starts flashing.
6. During charging, the battery indicator will blink. Once the battery is fully charged, the indicator will stop flashing.
7.If you will not use the product for a long time, charge the battery completely before storing it. Then charge the
battery at least once a month to prolong its life.
8.If the battery is damaged or cannot be charged anymore, do not try to open the product by yourselves. For
consultation and repair contact the shop from where you bought the product or the importer/ distributor.
9.The battery is recyclable. If the product is damaged and cannot be used any longer, take it to an official collection
point for electronic products' waste, batteries, chargers. DO NOT throw the product away with the household
waste. Follow your country's rules for the separate collection of electrical and electronic products and rechargeable
batteries. Dispose of waste of this type only at the designated places. This will be important and significant
contribution for the environmental protection and the reduction of the harmful effects of the substances contained
in batteries and electronic components on the environment and human health.
ATTENTION! NEVER STERILIZE, CLEAN WITH WATER OR SUBMERGE THE PUMP MECHANISM AND CHARGER IN
WATER!.. Follow the product assembly figures to ensure proper assembly.
1. Step 1 (Figure 1): Place the silicone valve (4) at the lower end of the linker (connecting element) (6). Make sure it
is inserted in the correct direction and fits tight around the ends of the linker. Important! If the valve is loose or not
installed correctly, it will not be possible to create a sufficient vacuum !
2. Step 2 (Figure 2): Insert the silicone cylinder (2) into the upper part of the linker. Make sure that it is properly
fixed around the ends of the linker opening intended for it.
3. Step 3 (Figure 3): Attach the pumping mechanism (1) to the linker (connecting element) (6). Make sure they fit
tightly together.
4. Step 4 (Figure 4): Attach the milk container to the bottom of the pumping mechanism and the linker (connecting
element). They should fit tightly together and there should be no gap between them.
5. Step 5 (Figure 5): With clean hands, insert the appropriate size silicone breast (nipple) shield. Make sure it is a
nice tight fit to the linker.
IV. BATTERY CHARGE
V. ASSEMBLY OF THE ELECTRIC BREAST PUMP
Parameters
150-270/mmHg
100-180/mmHg
3h
2.5
LED
Buttons
13