Pump Filter - Kuppersberg WDM 560 Technischer Pass

ENGLISH

7.3. Pump Filter

1
3
The pump filter system in your
Washing Machine prolongs the life
of the pump by preventing lint from
entering your machine.
We recommend that you clean the
pump filter every 2 months.
The pump filter is located behind the
cover on the front-lower right corner.
To clean the pump filter:
1. You may use the washing powder
spade (*) supplied with your machine or
liquid detergent level plate to open the
pump cover.
2. Lodge the end of the powder
spade or liquid detergent level plate
in the opening of the cover and gently
press backwards. The cover will open.
 Before opening the filter cover,
place a container under the filter cover
to collect any water left in the machine.
 Loosen the filter by turning
anticlockwise and remove by pulling.
Wait for the water to drain.
NOTE: Depending on the amount
of water inside the machine, you may
have to empty the water collection
2
container a few times.
3. Remove any foreign materials
from the filter with a soft brush.
4. After cleaning, re-fit the filter
by inserting it and turning clockwise.
4
5. When closing the pump cover,
ensure that the mountings inside the
cover meet the holes on the front panel
side.
6. Close the filter cover.
6
WARNING: The water in the pump
may be hot, wait until it has cooled
down before carrying out any cleaning
or maintenance.
(*) Specifications may vary depending on the
machine purchased.
(**) Instead of pump cover part, Plinth sheet
part is using in Built-in Machine. To remove
the plinth sheet part, please follow the Built-in
Installation Manual instructions.
7.4. Detergent Drawer
The use of detergent may cause
residual build up in the detergent
drawer over time. We recommend that
you remove the drawer every 2 months
to clean the accumulated residue.
To remove the detergent drawer:
 Pull the drawer forwards until it
is fully extended.
TECHNICAL PASSPORT
Washer Dryer
91