Electrical Connection - Kuppersberg WDM 560 Technischer Pass

ENGLISH
2. To increase the height of the
machine, turn the feet clockwise. To
decrease the height of the machine,
turn the feet anticlockwise.
 Once the machine is level,
tighten the locking nuts by turning
them clockwise.
3. Never insert cardboard, wood
or other similar materials under the
machine to level it.
 When cleaning the ground on
which the machine is located, take care
not to disturb the level of the machine.

3.3. Electrical Connection

 Your Washing Machine requires
a 220-240V, 50 mains supply.
 The mains cord of your washing
machine is equipped with an earthed
plug. This plug should always be
inserted to an earthed socket of 10
amps.
 If you do not have a suitable
socket and fuse conforming with this,
please ensure the work is carried out by
a qualified electrician.
 We do not take responsibility for
damage that occurs due to the use of
ungrounded equipment.
~ 95 cm
~ 145 cm
TECHNICAL PASSPORT
NOTE: Operating your machine
with low voltage will cause the life
cycle of your machine to be reduced and
its performance to be restricted.
3.4. Water Inlet Hose
Connection
1
3
1. Your machine may have either
1
a single water inlet connection (cold)
or double water inlet connection (hot
and cold) depending on the machine
specifications. The white capped hose
should be connected to cold water inlet
3
and red capped hose to the hot water
inlet (if applicable).
 To prevent water leaks at the
joints, either 1 or 2 nuts (depending
on your machine's specifications) are
supplied in the packaging with the
hose. Fit these nuts to the end(s) of the
water inlet hose that connect to the
water supply.
2. Connect new water inlet hoses
to a ¾˝, threaded tap.
~ 140 cm
~ 95 cm
Washer Dryer
3/4"
2
3/4"
4
2
4
61