Write Protection - RaidSonic Icy Box IB-1817MCT-C31 Schnellinstallationsanleitung

Quick installation guide IB-1817MCT-C31
Usage
• Connect the USB cable with the sole Type-C
enclosure
• Connect the Type-C
computer
• Once the IB-1817MCT-C31 has been plugged in correctly the LED
lights up white!
• The external enclosure can be connected or disconnected while the
computer is running.
• Please await the end of read/write operations before disconnecting
the device to avoid data lost.
• A new SSD must first be initialized, partitioned and formatted by the
operation system to be displayed by the system.
• If the drive is not recognized instantly by the operating system, please
check:
if the driver software is installed (USB).
if the SSD is initialized, partitioned and formatted.
The full USB 3.1 (Gen 2) transfer rate of up to 10 Gbit/s can only be achie-
ved with a compatible USB 3.1 (Gen 2) port on your host computer.

Write protection:

As soon as the write protection has been activated by switch, the LED lights
up red!
ATTENTION! A change of the write protect mode only takes effect if the
device has been disconnected and then reconnected to the host computer.
or Type-A adapter of the USB cable to your host
®
connector to the M.2
®