Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.
Wipe the door seal with clear water only and then wipe dry thoroughly.
5.
After cleaning reconnect and adjust the temperature control knob as desired.
6.
Put the food back into the appliance.
DEFROSTING THE FRIDGE
The refrigerator defrosts fully automatically. While the
cooling is running, beads of condensation or hoarfrost
form at the back of the refrigerator. This is normal. It is not
necessary to wipe off the condensation or frost. The rear
panel defrosts automatically. The condensation runs into
the condensation channel and is conveyed to the cooling
from where it evaporates.
Note: Keep the condensation channel and drainage hole
clean, so that the condensation can run out.
DEFROSTING THE FREEZER
A layer of frost in the freezer will impair refrigeration of the frozen food and increases power
consumption. Remove the layer of frost regularly. Do not scrape off frost or ice with a knife or
pointed object. Doing this may damage the refrigerant tubes.
1.
Remove the frozen food and place temporarily in a cool location.
2.
Disconnect the appliance from the mains socket.
3.
To accelerate the defrosting process, place a pan of hot water on a stand in the freezer.
4.
Wipe up condensation with a cloth or sponge.
5.
Wipe dry the freezer compartment.
6.
Plug in the appliance and put the frozen food back in the freezer.
VACATION TIME
For short vacation periods, leave the control knobs at their usual settings. During longer
absences;
1.
Remove all foods.
2.
Disconnect from electrical outlet.
3.
Clean the refrigerator thoroughly, including defrost pan.
4.
Leave door open to avoid possible formations of condensate, mold or odors.
POWER FAILURE
· Most power failures are corrected within an hour or two and will not affect your
refrigerator temperatures. However, you should minimize the number of door openings
while the power is off.
38
DO929RKZ-DO929RKC
Werbung
Inhaltsverzeichnis
