Firmware Update; Specifications - Monacor EPS110/RS485 Bedienungsanleitung

6.3.3 Saving the configuration file
Save the final configuration via the menu item "File ⇒ Save as..."
as "config .xml" to the root directory of the memory card (or save it
to the computer first and copy it to the memory card later) . To allow
EPS110/ RS485 to read the new configuration from the file, insert
the SD card, briefly disconnect the device from the power supply and
then reconnect it .

7 Firmware Update

To update the firmware:
1) Copy the firmware file to the root directory of the memory card .
2) Rename the file to "update .bin" .
3) Disconnect EPS110/ RS485 from the power supply .
4) Insert the memory card into the slot (4) .
5) Keep the recessed pushbutton SETUP (6) pressed while connecting
EPS110/ RS485 to the power supply .
6) Release the pushbutton when the status LED (5) starts flashing
rapidly .
After a few seconds, the status LED will stop flashing and the device
will start with the new firmware .
All rights reserved by MONACOR
No part of this instruction manual may be reproduced in any form or by any means for any commercial use.
22
® INTERNATIONAL GmbH & Co. KG.

8 Specifications

Output voltage: . . . . . . . . . . . . . . . 2 V at 600 Ω
THD: . . . . . . . . . . . . . . . . . . . . . . . . 0 .001 % at 600 Ω for 1 kHz
Memory cards: . . . . . . . . . . . . . . . . MMC / SD/ SDHC, 32 GB max .
Audio file formats: . . . . . . . . . . . . . MP3: 44 .1 kHz, 32 ... 256 kbit /s
D/A converter: . . . . . . . . . . . . . . . . 24 bit, stereo
Frequency response: . . . . . . . . . . . . 18 – 20 000 Hz, ±0 .02 dB
Digital volume control range: . . . . . 125 dB in steps of 0 .5 dB
Switching inputs: . . . . . . . . . . . . . . 7, active high +24 V
Supply voltage: . . . . . . . . . . . . . . . . ⎓ 7 – 24 V
Power consumption
with a load of 600 Ω at the audio outputs
for 7 V operating voltage: . . . 0 .4 W (60 mA)
for 24 V operating voltage: . . 0 .6 W (25 mA)
with16 Ω headphones: . . . . . . . . 1 .75 W max .
Housing: . . . . . . . . . . . . . . . . . . . . . for installation in top hat
Dimensions: . . . . . . . . . . . . . . . . . .
Weight: . . . . . . . . . . . . . . . . . . . . . 96 g
Ambient temperature range: . . . . . . −35 ... +55 °C
WAV: stereo 16 bit PCM,
44 .1 kHz
DIN rails according to DIN EN
60715, 2 DU
☞ drawing in chapter 4 .1
Subject to technical modification .