Grease Filters - Bosch DKE 985 H Gebrauchsanleitung

Filters and maintenance
Grease filters:
Metal filters are used to trap the greasy
element of the vapours that develop
during cooking.
The filter mats are made from non-
combustible metal.
Caution:
As the filter becomes more and more
saturated with grease, not only does the
risk of it catching fire increase but the
efficiency of the extractor hood can also be
adversely affected.
Important:
By cleaning the metal grease filters at
appropriate intervals, the possibility of them
catching fire as a result of a build-up of heat
such as occurs when deep-fat frying or
roasting is taking place, is reduced.
Saturation indicator:
When the grease filter becomes saturated,
the display symbol F appears. The grease
filter should be cleaned straight away.
Cleaning the metal grease filters:
In normal operation (1 to 2 hours daily),
the metal grease filter must be cleaned
after 8 to 10 weeks.
The filters can be cleaned in a dish-
washer. It is however possible that they
will become slightly discoloured.
The filter must be placed loosely, and
NOT wedged, in the dishwasher.
Important:
Metal filters that are saturated with
grease should not be washed together
with other dishes etc.
When cleaning the filters by hand, soak
them in hot soapy water first of all.
Then brush the filters clean, rinse them
thoroughly and leave the water to drain off.
F
Removing and inserting the metal grease
filters:
Warning: The halogen bulbs must be
switched off and cool.
1. Press the catch on the grease filters
inwards and fold the filters down. Fig. 2.
2. Clean the filters.
3. Insert the clean filters back into the
hood.
4. Cancel the F indication in the
display.
Swith the motor off (stop position).
Press for some seconds at the same
time 0 and T. A signal sounds and the
display symbol F at the side goes out.
If models feature side grease filters, remove
these filters also, Fig. 3.
1. Unscrew the plastic holder.
2. Remove the grease filters.
3. Clean and re-insert the grease filters.
Activated carbon filter:
For neutralizing odours in recirculating
mode.
Saturation indicator:
When the activated carbon filter becomes
saturated the display symbol C. Lights up
and a signal sounds.
Caution:
As the filter becomes more and more
saturated with grease, there is an increased
risk of fire and the function of the extractor
hood may be impaired.
Important:
Change the activated carbon filter promptly
to prevent the risk of fire from the
accumulation of heat when deep-fat frying
or roasting.
C
15