Start; Refuel; Throttle Control - Zipper Mowers ZI-MOS145G Originalbetriebsanleitung

All manuals and user guides at all-guides.com
OPERATION

15.1.4 Start

Assure yourself prior to every start that the fuel-oil
mixture is shook up well. Do not use self –mixed mix-
tures older than one month.
Check all machine parts for condition and all connec-
tions for tight set.
Put the main switch G into position I.
Apply the choker by putting lever J into upper position.
The choker is used for starting the machine when it is cold.
Then press 2-3 times the primer pump (28).
You find the primer between fuel tank and carburettor-
bottom.
Now start the engine buy pulling the starter K out briskly.
When the machine has started, shut the choker J off again.
Let the machine run for one minute in idle run.
TO STOP THE MACHINE IT IS ENOUGH TO PUT THE
MAIN SWITCH G INTO POSITON O (=STOP)

15.1.5 Refuel

Use 2-stroke HQ oil. Ask for advice from your local reseller.
ZIPPER Maschinen recommends using ready-mixed high qual-
ity fuel (e.g. ASPEN2). Self-mixed fuel disaggregates after a
certain time.
There is a risk of damaging the motor due to insufficient lu-
brication. Ready-mixed fuel never disaggregates even after
long periods of storage.
If you wish to mix your fuel yourself, you can use the mixing
cup L.
Fill the cup up with petrol until it reaches the mark 576,92.
Now fill the oil in until it reaches the mark 600.
Tighten the cap M well and mix the fuel by shaking the tank.

15.1.6 Throttle control

Press N.
Now you can press throttle lever O.
You can switch into continuous operation by pressing P
ZIPPER MASCHINEN GmbH  www.zipper-maschinen.at Seite 35
Motorsense / brush cutter ZI-MOS145G Seite 35