EarthQuaker Devices Ledges Bedienungsanleitung Seite 6

PRESETS
Ledges has six available preset slots for you to save and
recall your favorite settings. The settings for each of the
three controls, the mode switch and the expression jack
assignment can be saved and recalled in any of the slots.
Saving a preset
1. Turn the Preset rotary switch to the desired location
you wish to save your preset.
2. Dial in the settings you want to save. Remember;
expression pedal assignment and the selected Mode
can also be saved!
3. Hold the Save/Recall switch down until the LED
flashes between green and red and then release.
4. Your preset is now saved!
Recalling a preset
Select the desired preset you wish to use with the Preset
selector switch and do one of the two following actions:
1. When the pedal is activated and the effect is in use,
hold down the footswitch for at least 0.75 seconds, and
it will switch from Live Mode to Preset Mode. You can
switch between Live and Preset mode on the fly! Or:
2. Tap the lighted Save/Recall switch. The switch LED
will turn from green to red, indicating you are now in
preset mode. Tap again and the switch LED will turn
from red to green indicating you are in live mode.
Editing/Overwriting a preset
1. Once in Preset Mode (the lighted Save/Recall switch
LED will be red), make the desired changes to any of
6
the controls in the selected preset. The Save/Recall
switch LED will begin to flash red, indicating a change
has been made to the stored preset. Any controls
that are not changed will remain as previously saved.
2. Hold the Save/Recall switch down until the LED
flashes between green and red and then release.
3. The Save/Recall switch LED will return to static red
and the previous preset has been overwritten.
Helpful preset tips
• Different EXP assignments can be saved in each preset!
• Presets can be stored and overwritten when Ledges
is in Live Mode or Preset Mode.
• To make changes to an existing preset, you must first
be in Preset Mode before making the desired changes.
• There is no undo for preset saving, so make sure you
are not overwriting your favorite sound, especially
when you are saving presets from Live Mode!
EXPRESSION CONTROL
Use any TRS expression pedal to take control over the
Length, Damping or Mix! Ledges ships with the EXP jack
mapped to the Damping control. Follow these steps to
reassign the EXP functionality:
1. Insert the expression pedal TRS plug into the EXP jack.
2. Place the expression pedal in the toe down position.
3. Turn the panel control on the Ledges that you wish to
put under control of the expression pedal. It doesn't
matter how far or which direction you turn the control.
4. Put the expression pedal in the heel down position.
5. This control is now assigned to the EXP jack and can
be used with an expression pedal!