Overview Of The Components; Unpacking The Device - Clatronic VL 3741 S Bedienungsanleitung, Garantie

• This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental ca-
pabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance
in a safe way and understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by children
without supervision.
• Do not immerse the device into water for cleaning. Please fol-
low the instructions as stipulated in the chapter "Cleaning".

Overview of the Components

1 Hook
2 Propeller
3 Motor shaft
4 Motor
5 Adjustment knob for oscillation
6 Switch housing
7 Stand / gear casing connection screw
8 Nut for height adjustment
9 Cover cap
10 Stand tube
11 Screws for assembling the pedestal
12 Mounting plate
13 Pedestal
14 Operating mode switch
15 Rear protection grid
16 Fastening nut
17 Attachment ring for rear protection grid
18 Fastening screw
19 Fastening screw
20 Front protection grid
Not shown: Remote control

Unpacking the Device

1. Remove the device from its packaging.
2. Remove all of the packaging material such as foils, filling
material, cable holders and cardboard packaging.
3. Check the scope of delivery.
4. Check the appliance for any transport damage to prevent
a hazard.
VL3741S_IM VL3741S_IM
NOTE:
There may still be dust or production residues on the sur-
face of the device. We recommend that you quickly wipe
off the housing with a damp cloth.
Assembly Instructions
The device must be completely assembled before initial op-
eration!
NOTE:
• You will need a Phillips screwdriver of medium size for
the assembly.
• Screws not included as accessory are already pre-in-
stalled at the respective parts.
• Also observe the "Overview of the Components" on
page 3.
1. Place the parts of the pedestal together in the shape of a
cross.
2. Screw the mounting plate (12) tightly to the pedestal. To
do so, use the four Phillips-head screws.
3. Remove the nut for the height adjustment (8). Push the
covering cap (9) on to the lowest position of the upright
tube (10). Screw the height adjustment nut back on to the
upright tube (10).
4. Loosen the connection screw (7) and insert the gear cas-
ing (6) and the motor casing (4) on the stand tube. Then
tighten the connecting bolt by hand.
5. Unscrew the mounting ring (17) in an anticlockwise direc-
tion. Keep it ready to hand.
6. Position the rear protection grid (15) in place in accord-
ance with the recesses.
NOTE:
Please ensure that the carrying handle is facing up-
wards.
English
31
25.06.19 25.06.19