Overview Of The Components; Unpacking The Device - Clatronic VL 3602 Bedienungsanleitung

• This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental capa-
bilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by children
without supervision.
• Do not immerse the device into water for cleaning. Please follow the
instructions as stipulated in the chapter "Cleaning".

Overview of the Components

1 Hook
2 Propeller
3 Motor shaft
4 Motor
5 Adjustment knob for oscillation
6 Switch housing
7 Operating mode switch
8 Base
9 Rear protection grid
10 Fastening nut
11 Attachment ring for rear protection grid
12 Fastening screw
13 Fastening screw
14 Front protection grid
Not shown: crosshead screw

Unpacking the Device

1. Remove the device from its packaging.
2. Remove all of the packaging material such as foils, filling
material, cable holders and cardboard packaging.
3. Check the scope of delivery.
4. Check the appliance for any transport damage to prevent a
hazard.
NOTE:
There may still be dust or production residues on the surface
of the device. We recommend that you quickly wipe off the
housing with a damp cloth.
Assembly instructions
The device must be completely assembled before initial opera-
tion!
26
NOTE:
• You will need a Phillips screwdriver of medium size for
the assembly.
• Screws not included with the accessories are pre-fitted
on the individual parts.
• Also observe the "Overview of the Components" on
page 3.
1. Place the stand tube (6) in the base (8). Attach it on the
bottom with the crosshead screw (Not shown).
2. Unscrew the mounting ring (11) in an anticlockwise direc-
tion. Keep it ready to hand.
3. Position the rear protection grid (9) in place in accordance
with the recesses.
NOTE:
Please ensure that the carrying handle is facing upwards.
4. Turn the attachment ring (11) for the rear protection grid (9)
slightly in a clockwise direction.
5. Attach the propeller. Note the position of the guide pin on
the motor shaft.
6. Tighten the attachment screw (12) for the propeller in an
anticlockwise direction.
7. Remove the preassembled fastening screw (13) and nut
(10) from the wire mesh guard. Keep it ready to hand.
8. Hang the front protective guard (14) to the rear protective
guard with the hook (1).
NOTE:
Ensure that the holes for the attachment screw in the
front and rear protective grille are aligned one above the
other.
9. Secure the wire mesh guard with the fastening screw (13)
and nut (10).
10. Close the attachment hooks.