Infrared Panel; Iinstallation Instructions; Product Information; Declaration Of Conformity - Bosch HI4000P Installationsanleitung

HInstallation and use
▶ Do not install the device below a socket or near curtains or other
combustible materials.
▶ Do not use the heating near a bathtub, shower or swimming pool.
▶ Do not use the product in small rooms if these are used by persons
who are not able leave the room by themselves, unless the room is
continuously monitored.
HHot surface
Some parts of this product can become very hot and inflict burns when
they come into contact with the skin. Proceed with extreme caution if
children and vulnerable adults are present.
HRisk of overheating, risk of fire
To reduce the risk of fire:
▶ Do not place anything on the panel. Do not cover the appliance or
climb onto it.
▶ Ensure that the heat transfer from the panel is unhindered.
▶ Fasten the product to the wall or ceiling (with the exception of
ceramic variants and glass variants with 800W or greater).
HDanger to life from electric shock!
Touching a defective product or connecting lead may result in electric
shock.
▶ Do not use the product if it has been dropped.
▶ Do not use the product if there are visible signs of damage.
▶ Do not open the product.
▶ Avoid carrying out any interventions.
▶ Stop using the product and disconnect it from the mains power
supply.
▶ Please contact Service.
You can find the service addresses in chapter 11, page 17.
-or-
▶ Dispose of the product properly.
HSystem malfunctions caused by third-party equipment
This heat source is designed for operation with our control units.
System malfunctions, malfunctions and defects of system components
resulting from the use of third-party equipment are excluded from
liability.
Service work required to repair the damage will be invoiced.
According to the EU Directive 2009/125/EC - defined for the product
area of individual room heaters in Regulation 2015/1188 - the operation
of this infrared heater as a stationary individual room heater is only
permitted if certain control/regulation requirements such as weekday
control and window-open detection or, for example, adaptive control of
the start of heating are met. Detailed information on this can be found,
for example, on the Internet under:
content/DE/TXT/?qid=1596981415120&uri=CELEX:32015R1188.
To meet the above requirements and ensure comfortable operation of
this infrared heating system, select one of the corresponding control
components offered by Bosch (Bosch C-IR 20) or use an existing system
that meets these criteria.
HElectrical work
The panel is fitted with a three-conductor cable for 1/N/PE 230V/50Hz
with a plug for connection into a socket.
Electrical work must only be carried out by electrical installation
contractors.
Before starting electrical work:
▶ Isolate all poles of the mains voltage and secure against
reconnection.
Infrared panels – 6721851963 (2023/01)
https://eur-lex.europa.eu/legal-
▶ Make sure the mains voltage is disconnected.
The panel is fitted with a overheating protection.
The removal of the plug and shortening of the supply lead will not result
in loss of warranty. However, this must be performed by a technical
qualified person.
The supply cable must be fitted with a device for disconnection from the
mains voltage in which the distance between the disconnected contacts
is at least 3 mm for all poles.
If the supply cable of this appliance is damaged, it has to be replaced by
the producer or a service technician.
2

Product Information

These instructions contain important information for the system user
regarding safe operation of the Infrared panel.
The appliance must only be set up or mounted outside the safety zone
(shown in grey  Fig. 7, page 74).
For this:
▶ observe the installation instructions.
2.1

Declaration of conformity

The design and operating characteristics of this product comply with the
European and national requirements.
The CE marking declares that the product complies with all the
applicable EU legislation, which is stipulated by attaching this
marking.
The complete text of the Declaration of Conformity is available on the
Internet: worcester-bosch.co.uk.
2.2

Scope of delivery

The scope of delivery is shown in Fig. 1 at the end of the document.
▶ Check packaging upon receipt of delivery for damage.
▶ Check the scope of delivery for completeness.
[1]

Infrared panel

[2] Mounting frame
[3] Power supply cable
Technical documentation
Be sure to observe the requirements for the environmentally sound
design of individual room heaters according to Commission Regulation
(EU) 2015/1188.
According to this regulation, the operation of the infrared panel is only
permitted with an additional controller that can implement the functions
required in the regulation.
This controller must contain at least the electronic room temperature
control and weekday control as well as at least one further function
required by the directive, such as room temperature control with
detection of open windows or adaptive control of the start of heating.
Here we recommend the Bosch C-IR 20.
The panel is fitted with a limit thermostat which ensures its safe
operation.
2.3

Definition

The Infrared panel is subsequently referred to in this document as
"product", "panel" or "appliance".
Product Information
11