afx light LZR1000RGB-IP-FC Bedienungsanleitung Seite 7

Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or corrosion.
ATTENTION
: Danger of explosion if battery is incorrectly placed. Only replace by the same or equivalent type.
WARNING
:Do not swallow the battery. Danger of chemical burns. Keep new and old batteries out of the reach of children.
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact immediately a doctor.
Remote Control
• [INTR] key: Enter the built-in mix mode.
• [DMX] key: Professional DMX mode.
• [E-DMX] key: easy DMX mode.
• [1-9] key: number buttons from 1 to 9
- In the built-in mix mode, press the [1-9] button to enter the scene playback
mode. The number entered is the scene
- When the built-in sequence is played, press the [1-9] button to select the scene
number.
- In DMX mode or E-DMX mode, press the number button to set the address code.
- In the setting mode, you can select the projection range when setting the pro-
jection angle.
• [+][-] key:
- In the scene playback mode, press this key to adjust the scene number.
- Press this key to adjust the serial number in the sequence play mode.
- In DMX or E- DMX mode, press this key to adjust the address code.
- When setting mode, press this key to adjust the setting item.
• [SET] key:
- When the system is not in the set state, press 5 times to enter the system setting state.
- When the system is in the setting state, press this key to exit the system setting state.
• [RGB] key:
- Press this key to toggle the pattern colour. When the colour is changed, the display will tempo-
rarily display the currently set colour.
- This setting is temporary, and the system will return to the colour state (CLR) after switch off.
• [SEQ] key: Press this key to enter the sequence playback in built-in mode.
• [B-Out] key: Press this key to turn off the laser beam.
• [Sound] key:
- In the built-in mode, press this key to enable or disable the voice-control.
- When setting a mixed sequence, you can enable or disable a sequence.
- You can enable or disable the mirror when setting the graphic X mirror, the graphic Y mirror,
and the XY for the graphic.
- You can enable or disable the remote control when setting the remote control function.
• [ENTER] key: When entering a number that is lower than 100, press this key to speed up the
digital input.
IMPORTANT NOTE: Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local
authorities or your dealer about the way to proceed.
www.afx-light.com
7 EN