Nordcap VAR-PH14 Bedienungsanweisung Seite 12

PARETE H - MOD H
Place the cabinet on the floor. If applicable, place the cabinet on the stand and tighten the stand/cabinet fixing bolts, fitting them
from the lower part of the stand.
Before fitting the cabinet into the recess, fix the aluminum spacer in the middle of the wall 20 mm above the height of the cabinet
in question, as per 3.2 (pic. 4)
Screw the small bracket on the top side of the upper beam (pic. 5)
Fit the cabinet into the recess and screw the bracket mounted on the top beam of the cabinet to the spacer previously attached to
the wall (pic. 6)
4
For correct operation the unit should be placed in a place free of excessive moisture, well-ventilated and away from sources of
heat, the ambient has to be with temperatures between 5 ° C and 30 ° C, avoiding exposure to direct sunlight, keeping it clean
from dust or other sediments.
Any damage caused by failure of following these recommendations is not covered by the guarantee and is not in any way the
manufacturer's responsibility.
It is also recommended to place the appliance so it can be used under NORMAL lighting conditions(defined as 200 LUX) E.D.
2006/42/EECE
Place the display on a even and flat surface, if needed regulate the four front and rear leveling feet to get a perfect level.
Important for its correct functioning and to allow the doors to close properly it is essential that it is perfectly level.
The installation and any maintenance operation on the equipment must be performed by a qualified technician or a service center.
Never connect the plug to an ungrounded socket and always check that its grounding is conform to the applicable local rules.
Do not install the appliance in a place subject to gas leaks.
When moving, in order to prevent damage to the floor, make sure the leveling feet are raised.
The display should not be placed outside or exposed to direct sunlight.
Once placed in the final position, leave the showcase turned off at least 4 hours, this reduces the possibility of malfunction of the
refrigerating system due to transport and handling.
• Insert the plug into the wall socket (see electrical system safety)
• To start operating the appliance act on the main switch located under the display on the right side (TECA) or on the front
lower side (PARETE - MOD)
• Turn on the display by pressing the power button of the controller (
• Let the machine run empty for at least two hours before inserting bottles / food
• At the beginning the unit might be noisy; gradually, letting the machine run, the noise will decrease
• The compressor will start automatically after a few minutes, if the unit is turned off and immediately turned on again or when
setting temperature, the compressor stops and starts automatically after a few minutes
The cabinet's back refrigeration system (5.3) works with a static condensation system. Air intake, necessary to cool the
condenser, takes place from the bottom of the cabinet, i.e. the 4cm space where the feet are placed. DO NOT FOR ANY REASON
CLOSE OR OBSTRUCT THIS SPACE.
Not following the above instruction, not only creates a significant increase of consumption but can lead to serious malfunction or accident
and is considered as improper use, faulty installation or tampering and therefore will INVALIDATE THE PRODUCT WARRANTY.
Failure to comply with the above suggestion could affect the good operation of the unit and increase the electric consumption.
The showcase must be installed in order to allow easy movement for maintenance and cleaning operations.
The back side of the refrigerated unit must be placed at least 10 mm from the wall.
5
DO NOT CLOSE THE SPACE UNDERNEATH THE BASE.
ALSO THE PARTIAL CLOSURE WITH INHIBIT THE VENTILATION.
FAILURE TO COMPLY THESE INSTRUCTIONS INVALIDATE THE WARRANTY.
LEAVE THIS SPACE FREE
) (see legend of key symbols)
CAUTION
12
ENGLISH
6