Nordcap VAR-PH14 Bedienungsanweisung Seite 11

ENGLISH
Do not make any changes or modifications since a different configuration could result in damage to property or persons. Expo Srl
cannot be held liable for safety issues and damages resulting from such changes.
The warnings and safety instructions in this manual do not cover all possible conditions and situations that may occur, therefore
it is the user's responsibility to use the appliance with common sense, paying the utmost attention and care during installation,
maintenance and operation.
Since these instructions cover various product models, the characteristics of the purchased product may differ slightly from the
ones described in this manual. Maximum surface weight load 15 kg. A-weighted sound level is under 70 dB.
3. INSTALLATION
The unit is delivered in carton boxes on wood pallets. During transport and handling do not remove the product from its
packaging and use a mechanically operated device to move it. To handle the unit in order to place it (after removing the package),
it must be handled by holding the lower base. Gloves are mandatory.
Remove the cardboard packaging and styrofoam guards.
Due to the reduced depth of the cabinet – which compromises its stability – all operations from packaging removal to complete
installation of the cabinet must be carried out by at least two operators.
3.1 Positioning
Remove the two metal brackets fixing the cabinet to the pallet, making sure the cabinet is in the upright position. Place the
cabinet on the floor near where it is going to be installed.
3.2 Wall fixing
Fix the cabinet to the wall using the provided brackets. The type of screw and wall plugs to use is to be decided by the technician
according to the support (drywall, brickwork, wood, etc.). Wall fixing varies depending on the model as explained below.
TECA H
Fix the provided bracket to the middle of the back wall. Set the cabinet against the wall, aligning it with the previously attached
bracket. Use the provided screw to fix the cabinet to the bracket.
TECA BH
Place the cabinet on the stand (if applicable) and tighten the stand/cabinet fixing bolts, fitting them from the lower part of the stand.
Fit 2 anchors to the right and 2 anchors to the left of the inner part of the recess, 13mm from the outer border – one on the upper
side and one on the lower side of the cabinet (pic. 1).
Screw the provided brackets in the upper side of the recess – left and right side – 31 mm from the side walls and 7 mm from the
front wall. The bracket myst be fixed with the threaded hole facing outward from the recess (img. 1).
Move the unit in the recess (pic. 2).
Screw the provided threaded pivots onto the bracket previously fixed to the wall (pic. 3).
Put the frame in place and press to snap it on.
Fit the magnetic panel to the base of the stand (if applicable).
1 2
11
3