KERN ODC-89 Bedienungsanleitung

KERN ODC-89
Version 1.0 01/2016
GB
User instructions
USB microscope
Before use
You should ensure that the device is not exposed to direct sunlight,
temperatures which are too high or too low, vibrations, dust or a high level of
humidity.
The ideal temperature range is between 0 and 40°C and a relative humidity of
85% should not be exceeded.
Always make sure that you use an approved power cable. Thus possible
damages by reason of the development of overheating (fire hazard) or an
electric shock can be prevented.
Do not open the housing and touch the internal component. There is the risk of
damaging them and affecting the functionality of the camera.
In order to carry out cleanings always disconnect the power cable from the
mains supply.
Always keep the sensor clear from dust and do not touch it. Therefore do not
remove its protective housing. Otherwise there is the risk of affecting the
microscopic image. In case of non-use always attach the protective covers.
Technical data
Model
Resolution Interface Sensor
KERN
ODC 894 2 MP
USB 2.0 1/3,2" CMOS
ODC 895 2 MP USB 2.0 1/3,2" CMOS
Model
Magnification Focusing stand
levels
KERN
ODC 894
10x, 200x Coaxial
ODC 895 10x, 200x Focus wheel
ODC-89-BA-e-1610
Frame rate Colour / Supported operating
Mono- systems
chrome
15 - 30 fps Colour Win, XP, Vista, 7, 8, 10
15 - 30 fps Colour Win, XP, Vista, 7, 8, 10
Illumination
8x LED
8x LED
Scope of delivery
-
USB microscope (USB cable incl.)
-
Microscope stand
-
Software CD
Free download:
www.kern-sohn.com > DOWNLOADS > SOFTWARE > Microscope VIS Basic / Pro
Mounting + functionalities
1. Remove the cover at the bottom of the microscope.
2. Mount the microscope stand and put it onto an even table
surface. Afterwards attach the microscope on the ring holder of
the stand.
3. Establish USB connection to a PC via USB cable.
4. Installing the software with help of the CD.
Detailed instructions can be found in the supplied "readme"-file.
5. Both the supplied "Help"-files and the software-internal "User
Guide" include all information and instructions about the
operation of the software or of digital microscopy.
6. As soon as the software has been started and the image
transmission launched, adjust the illumination level by using the
control wheel, located on the cable.
7. The adjustment of the magnification level is done by using of the
control wheel, located on the side of the microscope.
8. The height adjustment of the microscope stand is done by using
the focus wheels. For the KERN ODC 894 it is aligned coaxial
and for the KERN ODC 895 double-sided on the stand pillar.
9. The USB microscope can also be used without microscope
stand. It can be easily directed towards the specimen by hand.
10. For capturing a snapshot the knob, located on the side of the
microscope (above the control wheel for the magnification
adjustment), needs to be pressed.