Corrective Action - Bosch 06008B8001 Originalbetriebsanleitung

OBJ_BUCH-3472-001.book Page 24 Thursday, December 21, 2017 4:11 PM
24 | English
Bucking a Log (see figures K–N)
Bucking is cutting a log into lengths. It is important to make
sure your footing is firm and your weight is evenly distributed
on both feet. When possible, the log should be raised and
supported by the use of limbs, logs or chocks. Follow the
simple directions for easy cutting.
When the log is supported along its entire length, it is cut from
the top (overbuck).
When the log is supported on one end, cut 1/3 the diameter
from the underside (underbuck). Then make the finished cut
by overbucking to meet the first cut.
Troubleshooting
The following chart lists problem symptoms, possible causes and corrective action, if your power tool does not operate properly.
If these do not identify and correct the problem, contact your service agent.
 Warning: Switch off and remove the battery prior to any troubleshooting.
Problem Possible Cause
Chain saw fails to Battery discharged
operate
Battery not fully connected
Motor protector has activated
Battery too hot/cold
Saw chain will not Battery discharged
move
Power tool defective
Chain saw operates Internal wiring defect
intermittently
On/Off switch 2 defective
Saw chain dry No oil in reservoir
Vent in oil filler cap 4 clogged
Oil passage clogged
Saw chain/guide bar No oil in reservoir
hot
Vent in oil filler cap 4 clogged
Oil passage clogged
Chain tension too high
Blunt saw chain
Chain saw rips, Chain tension too loose
vibrates, does not
Blunt saw chain
saw properly
Saw chain worn out
Saw chain teeth are facing in the wrong direction
Excessive vibrations/ Power tool defective
noise
F 016 L81 719 | (21.12.17)
When the log is supported on both ends, cut 1/3 the diameter
from the top overbuck. Then make the finished cut by
underbucking the lower 2/3 to meet the first cut.
When bucking on a slope, always stand on the uphill side of
the log. When "cutting through", release the cutting pressure
near the end of the cut without relaxing your grip on the chain
saw handles in order to maintain complete control. Don't let
the chain contact the ground. After completing the cut, wait
for the saw chain to stop before you move the chain saw.
Always stop the chain saw motor before moving from tree to
tree.

Corrective Action

Recharge battery; also see "Battery Charging"
Ensure both locking levels are engaged
Allow motor to cool
Allow to cool/warm
Recharge battery; also see "Battery Charging"
Contact Service Agent
Contact your Bosch Service Centre
Contact your Bosch Service Centre
Refill oil
Clean oil filler cap 4
Clean oil passage
Refill oil
Clean oil filler cap 4
Clean oil passage
Tension saw chain
Replace saw chain
Tension saw chain
Replace saw chain
Replace saw chain
Reassemble with saw chain in correct direction
Contact Service Agent
Bosch Power Tools