Axis M1103 Installationsanleitung Seite 11

AXIS M11 Series
Adjust image and focus
To focus AXIS M1103/M1104:
Unscrew the focus puller on the lens. Adjust the
focus as required. Re-tighten the focus puller.
Note: Grip the outer rim of the lens while focus-
Hardware overview,
sing (see
Gripping the whole lens could cause the
lens to come unscrewed.
To focus AXIS M1113/M1114:
Click the Setup link at the top, right in the camera's web interface
1.
and go to Basic Setup > Focus.
In the Focus Adjustment page set the DC-Iris to Disabled and click
2.
Save.
3. Unscrew the zoom puller on the lens by turning it anti-clockwise.
Adjust the zoom setting as required. Re-tighten the zoom puller.
4. Unscrew the focus puller on the lens. Adjust the focus as required.
Re-tighten the focus puller.
From the Focus Adjustment page, set the DC-Iris to Enabled and
5.
click Save.
Notes:
• The DC-Iris should always be
disabled while focusing the
camera. This opens the iris to its
maximum, which gives the
smallest depth of field and thus
the best conditions for correct
focusing. When the focus is set
with this method it will then be
maintained in all light conditions
• The design of AXIS M11 Series
allows for slight lens movement to
ensure sensor alignment.
on page 4).
Lens
Focus puller Zoom puller
Page 11
r
Focus pulle