7.2.3 Install without Measuring Chamber
This is the full flow installation. The sensor is in the pipe.
Install through a nozzle
7.3 Remove the Dew Point Transmitter
Unscrew the device off the measurement chamber or from the nozzle.
Please make sure that the system is pressure-less before the Dew Point
Transmitter is removed.
16
5/8" UNF
• Install the device only
if the system is
pressure-less.
• Check the size of the
nozzle and make sure
that no less than 1/3
of the sensor tip is
inside of the pipe.
• The inner thread of
the nozzle must be
UNF 5/8".
7 Installation
PTS+20/-100