Changing Batteries - Cherub A520012 MISTRAL Einstellanleitungen

To deactivate the MISTRAL proceed as following:
- Open the awning completely and wait for at least ten seconds after the terminal bar has
stopped moving before beginning to unsnap the sensor.
- Press both snap hooks sideways at the same time while pulling the shell downward,
until it comes away from its base. Use no tools for this procedure (screwdrivers, or
similar items).
- As soon as the shell has been unsnapped, rotate the selector to the 0 position: the LED
will then flash three times slowly (0.5 seconds ON - 0.5 seconds OFF), to confirm the
fact that the sensor has been deactivated and cannot trip an alarm.
SELECTOR
To enable the sensor once again, follow the activation procedure as indicated
on page 23.
To make any changes to the alarm trip thresholds, to change the batteries or to perform
any other programming operation, the shell must be unsnapped from its base. To perform
this procedure, without the sensor tripping an alarm that will close the awning, creating
a potentially hazardous situation for persons in the vicinity, it's necessary to disable the
MISTRAL (check paragraph DISABLE THE SENSOR).
When the batteries are almost drained, the LED will flash regularly every two seconds.
Change the batteries.
When changing the batteries, it's possible to use the Automatic Deactivation of
the sensor:
- Unsnap the shell from the base
- Rotate the shell and keep it vertical for
around 3 seconds
- The sensor will automatically deactivate.
When the new batteries are placed, the sensor will reactivate automatically: just snap
again the shell on the base.
Under normal use conditions, the batteries should last over two years. In any event, it is
suggested that the batteries be changed at the beginning of each new season.
DISABLE THE SENSOR
MAINTENANCE

CHANGING BATTERIES

27
3 sec