Cherub A520012 MISTRAL Einstellanleitungen Seite 24

Before assembling the shell on the base:
- Rotate the selector to a middle value from 1 to 9 (e.g. 5).
- Activate the sensor by pressing the SET button for at least 4 seconds until the LED
flashes twice quickly.
4
PROCEDURE
- Snap the shell onto the base.
- Stand by for 10 seconds until the sensor detects the rest position and the motor makes
its confirmation movements*.
Within three minutes proceed with the SENSOR TEST OPERATION.
*Note: for Wave RX motors manufactured before 01/2013 and TDS Gold control units
manufactured before 04/2013 the procedure ends without confirmation movements.
SENSOR ACTIVATION
5
set
SELECTOR
4 sec
10 sec.
........
24
*