Troubleshooting - ECG 24 H03T2S2 Bedienungsanleitung

TROUBLESHOOTING

Problem
No power
Bad signal reception
GB
No image
The picture is fine, but no sound
The sound is fine, but there is no picture
or the colours are incorrect
Snowy picture, noise or picture freezes
Interfering horizontal stripes through the
picture
The TV does not respond to the remote
control
No picture in PC mode
Vertical vibration (in PC mode)
The picture in PC mode is too light or
dark
If the instructions above do not eliminate the issue, unplug the TV from the power supply for about 60 seconds
and then plug the TV in again� Should the issue persist, refer to a qualified repair shop� Do not attempt to repair
the appliance yourself�
Do not leave the TV with a static picture for a long time (video pause, display of menu, etc�)� There could be
permanent burning of the static picture and damage to the display�
140
Solution
• Make sure the power cord plug is plugged into the
electric socket� Unplug the TV from the power supply,
wait about 60 seconds and then plug the TV in again and
power on�
• High buildings or hills can lead to analogue signal
reflection and shadows� Changing the antenna
orientation can improve picture quality�
• If you use an inside antenna, reception can be worse
under certain circumstances� Try changing the antenna
positioning to improve reception� If the picture does not
improve, use an outdoor antenna�
• Make sure the antenna is correctly connected to the TV�
• Try changing to a different channel to verify the issue is
not your receiver�
• Increase the volume�
• Make sure the sound on the TV is not muted� Press the
mute button again to restore the previous volume�
• Increase the contrast and brightness�
• Make sure the antenna connection is correct�
• Interference caused by electric appliances, such as hair
dryers or vacuum cleaners� Switch off appliances used
near the TV�
• Aim the remote control towards the remote control
sensor on the TV�
• Remove any obstacles between the remote control and
the TV sensor�
• Make sure the batteries in the remote control are not
dead�
• Make sure the video cable connection to the VGA
connector is intact�
• Makes sure the format of the picture from the PC is
compatible with this TV�
• Adjust the display frequency for the picture from the PC�
• Adjust the brightness and contrast�