Type
Mode
Time start�
Time end
If a set time conflict occurs, a warning message appears�
Signal information
You can view information about the received signal in this menu� This function is not accessible for an analog
reception�
CI information (requires CA module input)
With this feature you can call up and configure the information about the inserted CA module�
Setting satellite
You can access this menu if you select Satellite as your signal source� Here you can select, add, delete and edit
satellites and their transponders� You can also start automatic tuning of one or more satellites or transponders
from this menu�
The left table shows an overview of pre-loaded satellites� If you mark one or more satellites by pressing OK, you
can start their auto-tuning by pressing the blue button Scan�
Schedule setup
1 ONE HD
Recorder
Once
11:47 05 Lis
12:17 05 Lis
Select
Back
Signal information
Channel: 5 (177�50 MHz)
Unknown modulation
Quality 100 (Good)
Signal 0 (Weak)
Setting satellite
Satellite
Quality
TransPonder
OK Select
Exit
Delete
The record is successfully saved
Recorder 11:47 ~ 12:17 on CH�1
05/11/2016
Network
Ku HOTBIRD 6,7,A,8
Type LNB
LNB power
22 kHz
Toneburst
DiSEqC1�0
DiSEqC1�1
Motor
Edit
Scan
Add
Exit
09750/10600
13/18V
Auto
None
LNB2
None
None
GB
123