Bosch DIA096051 Gebrauchsanweisung Seite 16

Filters and maintenance
Inserting the filter:
Warning: The halogen bulbs must be
switched off and cool.
1. Remove the metal filters (see "Removing
and inserting the metal grease filters").
2. Insert the activated carbon filter.
Fig. 2.
3. Raise the activated carbon filter in front
and rotate the closures by 90°. Fig 3.
4. Insert the metal grease filters (see
"Removing and inserting the metal
grease filters").
5. Cancel the in the display.
ã
❑ Press the 0 button twice in rapid
succession. A signal sounds and the
display symbol
Removing the filter:
Warning: The halogen bulbs must be
switched off and cool.
1. Remove the metal filters.
2. Rotate the closures by 90° and remove
the activated carbon filter downwards.
Fig. 3.
3. Insert the metal grease filters.
16
goes out.
ã
Replacing the activated carbon filter:
During normal operation (1 to 2 hours
per day) the activated carbon filters
should be replaced approximately 1 x
year.
A replacement filter can be obtained
from any authorized dealer.
Use original filters only.
By doing so you will obtain maximum
performance from your extractor hood.
Disposing of the old activated carbon
filter:
There are no pollutants in the activated
carbon filters. They can therefore be
disposed of as part of your normal
domestic refuse.