Automatic Shut-Off - CO/Tech MDDG-20DEN3-QA3-UK Bedienungsanleitung

4. Set the desired start time by pressing or holding down [ - ] or [ + ].
5. After a few seconds the display reverts to showing the current humidity and
the timer indicators light up to show that the timer settings are activated.
6. The [ Timer ] button can be pressed at any time to check the settings.
7. The timer settings can be changed at any time by pressing [ Timer ] and then [ - ] or [ + ].
• If the dehumidifier is switched off after the timer settings have been made,
the settings will be deleted.
• If the water reservoir fills up ("P2" appears on the display) while the dehumidifier is
operating and before the set timer time has been reached, the timer setting will
be deleted.
When the dehumidifier is switched off:
1. Press [ Timer ], the start timer indicator lights up.
2. Set the desired start time by pressing or holding down [ - ] or [ + ]. Each press
changes the time in 30-min increments up to the 10-hour mark. Thereafter in
increments of 60 minutes.
3. Press [ Timer ] again, the stop timer indicator lights up.
4. Set the desired stop time by pressing or holding down [ - ] or [ + ].
5. After a few seconds the display reverts to showing the current humidity and
the timer indicators light up to show that the timer settings are activated.
6. The [ Timer ] button can be pressed at any time to check the settings.
7. The timer settings can be changed at any time by pressing [ Timer ] and then [ - ] or [ + ].
• If the dehumidifier is switched on after the timer settings have been made,
the settings will be deleted.
• If the water reservoir fills up ("P2" appears on the display) while the dehumidifier is
operating and before the set timer time has been reached, the timer setting will
be deleted.

Automatic shut-off

• When the water reservoir becomes full during normal use, the dehumidifier's
compressor shuts off automatically.
• The fan continues for another 30 seconds to dry the inside of the dehumidifier.
• The dehumidifier beeps 8 times, the "Water Full" LED indicator flashes and "P2"
appears on the display.
8