Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4 CONTROLS AND DISPLAY
6
7
8
I
AUTO O
RUN P1 P2
1 2
3
4
5
6
P
1...7
h
Set
R
9
10
11
14
62432.LT.AL.REM.002
Keys
Function
7
Sliding switch to set operating mode:
I:
Permanently ON
AUTO:
Switch ON and OFF in accordance with programmed switch times
O:
Permanently OFF
8
Sliding switch to set Time and Switch Times:
RUN:
Switch program and clock run
P1:
Input switch times for Channel 1 (CH)
P2:
Input switch times for Channel 2 (DHW)
9
P-Button for programming the 16 switch points.
When time switch points 1, 3, 5, 7, 9, 11, 13, 15, (activate time points) are selected, the lamp symbol ☼ will appear
in the right of the display.
If time switch points 2, 4, 6, 8, 10, 12, 14, 16 (switch OFF time points) are selected, there will be no symbol.
10
1...7: Button to input the day of the week (current day and switching day). When programming timing points and
individual days the following block day programmes are also possible:
1..5 (Monday to Friday)
1..6 (Monday to Saturday)
6..7 (Saturday to Sunday)
1..7 (Monday to Sunday)
11
h:
Button to input hours
12
m:
Button to input minutes
11+12
simultaneously pressing of buttons „h" and „m" for 2-3 seconds enables the time of day to be set.
13
-x->
Skip-Function: Pressing the Skip-button '-x->' results in the fitted timer reverting to the opposite function
mode.
For example: If the timer is in „switched ON" mode, it will be immediately switched off and vice-versa.
14
R:
Reset button will delete all switching times and current time of day
table 03
Control panel
7
m
12
13
(for current time and switching time)
(for current time and switching time)
Before the first commissioning/progamming a Reset must be
carried out:
•
Ensure that the right sliding switch is in the RUN position.
•
Press button „R" with the point of a biro or similar imple-
ment. The Display will start to flash 0 00.
In relation to days of the week, the timer may be optionally
printed with: m..su or 1..7 and day or P
7
Werbung
Inhaltsverzeichnis
