Setting The Switch Of Point; Checking, Changing And Deleting Switching Times - REMEHA Avanta Plus Timer Bedienungsanleitung

2-Channel time clock
4.2.3 Setting the Switch OFF Point
Proceed as follows:
• Press button „P". The next switch point (switch OFF) is
displayed.
• Press button „1...7" to input the day of the week or blocks
of days. Continuous pressing of this button allows you to
select individual days or blocks of days.
• Press buttons „h" and „m" to set the time.
• Repeat steps 2 to 3 as often as required.
After setting the desired switching times: Set the left sliding
switch to position AUTO and the rightsliding switch to position
RUN.
The timer will now operate according to the programmed
switching times.

4.2.4 Checking, changing and deleting switching times

Proceed as follows:
• Set the right sliding switch to position P1 (Channel 1, CH)
or P2 (Channel 2, DHW).
Checking Press button „P" as often as necessary
to show the desired switching point in the
Display.
Changing Use button „P" to flag up the desired
„saved" location.
Press buttons „1...7" to change the day
of the week.
Press buttons „h" and „m" to change the
switching time, as described earlier.
Deleting Use button „P" to flag up the desired
„saved" location.
Then press button "-X->" and button „P
simultaneously for 3 – 4 seconds.
The Display will show a flashing 0:00 and
the switching point is deleted.
table 05 Switching times
• If the check, change or deletion is complete set the right
sliding switch back to position RUN.
10