Makita DTW251 Bedienungsanleitung Seite 3

ENGLISH (Original instructions)
1-1. Red indicator
1-2. Button
1-3. Battery cartridge
2-1. Star marking
3-1. Switch trigger
4-1. Lamp
5-1. Reversing switch lever
6-1. Socket
SPECIFICATIONS
Capacities
No load speed (min
Impacts per minute
Max. fastening torque
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for fastening bolts and nuts.
Noise
The typical A-weighted noise level determined according
to EN60745:
Model DTW250
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Model DTW251
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Explanation of general view
6-2. Anvil
7-1. Socket
7-2. O-ring
7-3. Pin
8-1. Hook
8-2. Screw
8-3. Groove
10-1. Limit mark
Model
Standard bolt
High tensile bolt
Square drive
-1
)
Overall length
Net weight
Rated voltage
) : 90 dB (A)
pA
) : 101 dB (A)
WA
) : 94 dB (A)
pA
) : 105 dB (A)
WA
DTW250
M10 - M16
M10 - M14
12.7 mm
0 - 2,200
0 - 3,200
230 N.m
165 mm
1.6 kg
D.C.14.4 V
ENE036-1
Vibration
The vibration
ENG905-1
determined according to EN60745:
Model DTW250
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model DTW251
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test method
and may be used for comparing one tool with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the power
•
tool can differ from the declared emission value
depending on the ways in which the tool is used.
Be sure to identify safety measures to protect the operator
•
that are based on an estimation of exposure in the actual
3
11-1. Rear cover
11-2. Screws
12-1. Spring
12-2. Arm
12-3. Recessed part
13-1. Carbon brush cap
14-1. Hole
14-2. Carbon brush cap
DTW251
M10 - M16
M10 - M14
12.7 mm
0 - 2,100
0 - 3,200
230 N.m
165 mm
1.5 kg
D.C.18 V
total value (tri-axial
2
) : 14.5 m/s
h
2
2
) : 11.0 m/s
h
2
ENG900-1
vector sum)
ENG901-1