Product Description; Technical Specification; Mode Of Operation - PestWest Chameleon SIRIUS X Gebrauchsanweisung

ENGLISH: Chameleon
®
INSTRUCTIONS FOR USE AND MAINTENANCE * PLEASE SWITCH OFF MACHINE BEFORE SERVICING

PRODUCT DESCRIPTION

All PestWest flytraps are made using the highest quality materials. The bodywork is polyester powder coated zintec
steel (rust-resistant) with a polished aluminium reflector (Stainless steel 304 Grade front cover also available). The
Chameleon Sirius X retains a PestWest sticky board and is fitted with next generation Quantum X LED filament lamps
with a peak wavelength of 370nm coated with FEP shatter-ressistant coating as standard.
The new Quantum X LED filament lamp is made with the familiar T5 form factor (glass tube, end caps and pins) used
in our conventional 14W T5 fluorescent Quantum Lamps.
The main advantages of the Quantum X LED filament lamp technology are the extended pattern of light distribution
and the improved energy efficiency. Increased fly attraction is partly due to the LED filaments light distribution, which
is around 360 compared with only 120
O
first-generation LED insect light traps. LED filaments are also more energy efficient than both high power SMD UV-A
LEDs and also conventional fluorescent lamps.
The Quantum X LED filament lamp consists of 18 individual LED filaments mounted on a frame and hermetically
sealed within a glass tube with a state-of-the art gas cooling system, which is far superior to traditional metal heat
sinks.
Each filament has 24 individual LEDs which are mounted on a transparent substrate, which enables the Quantum X
LED lamp to provide light in all directions. The combination of 360
produced by far more LEDs (432 per lamp) gives the Quantum X superior fly catching performance.

TECHNICAL SPECIFICATION

Voltage Range
Frequency Range
Power Consumption
Ingress Protection Rating
Classification
Ambient operating temperatures
LED Driver type
Area of Coverage
Sticky board
LED Lamp type
Mounting Method
Unit Dimensions mm
Weight
UNPACKING YOUR UNIT
Each unit is carefully inspected and packed before leaving our factory. Before discarding the outer carton, examine
for obvious evidence of transport damage. Remove the unit and pay particular attention to the removal of all packing
materials, before installing the unit.

MODE OF OPERATION

Electrical flytraps operate on the principle that most flying insects are attracted to light, particularly to the ultraviolet
(UV) end of the light spectrum. Since insects are still active and will fly at night, traps should be left operating 24 hours
a day.
SITING
The efficiency of the unit can be affected by the intensity of other light sources, e.g. daylight.Therefore, mount the unit
where competition from other light sources is minimised. In food areas, mount close to, but not directly over, exposed food or
preparation surfaces (preferably to attract flies away from sensitive areas rather than attract towards them). Observe where the
flies tend to congregate and if possible, put your flytrap in or close to that area. Site the units near where flies are likely to
gain access, e.g. doors and windows opening to the outside, especially dustbin areas.
Sirius X
typical of high power SMD (Surface Mounted Device) LEDs found in older
O
light distribution and the softer intensity of light
O
220-240V
50-60Hz
13.5W
20
Class 1
0 to +40°C
Constant Current
50 - 60m
2
135-000226 LED 21" STICKY BOARD
130-000321 Quantum X LED 370nm 550mm T5 Shatter-Resistant
Wall Mounted
H190 x W580 x D120
3.1 kg