Einführung; Wichtige Sicherheitsinformationen - Philips Senseo HD6592 Bedienungsanleitung

You have not
preheated the cups.
You have added cold
milk to the coffee.
The filter coffee is You have not brewed
not hot enough. a full jug.
You have not
removed the pod
holder.
You have not
preheated the
insulated jug.
You have added cold
milk to the coffee.
Coffee grounds Your paper filter
end up in the collapsed during
insulated jug. brewing.
The coffee is There was some water
weaker than in the insulated jug
expected. when you started
brewing filter coffee.
You have not used
enough pre-ground
coffee.
Water leaks from You overfilled the
the coffee machine. water reservoir.
The sieve in the center
of the pod holder may
be clogged.
The sealing ring is
stuck under the edge
of the distribution disk
in the lid.
You forgot to place
the collector ring.
I cannot open the A vacuum has formed
lid. under the lid.
It takes longer than You have to descale
before to brew the machine.
filter coffee.
You left a pod holder
in the machine.
Rinse the cups with hot
water. You can preheat the
coffee machine and cup by
brewing a cup of hot water
first without placing a coffee
pod in the pod holder.
Do not use cold milk straight
from the refrigerator.
Coffee stays hot longer if
you brew a full jug of coffee.
If you do not remove the
pod holder, this can lead to
a longer brewing time.
Rinse the insulated jug with
hot tap water to preheat it .
Do not use cold milk straight
from the refrigerator.
To prevent the paper filter
from collapsing, fold the
sealed edges.
Always make sure that there
is no water in the jug when
you start brewing coffee.
Use one heaped measuring
spoon of pre-ground coffee
per cup for stronger coffee.
Do not fill the water reservoir
beyond the MAX level.
Check the pod holder. If
the sieve is clogged, use a
washing-up brush to unclog
the sieve. If you cannot
clean it properly with the
washing-up brush, put the
pod holder in the machine
and descale the machine.
Check if the sealing ring is
stuck under the edge of
the distribution disk. If it is,
pull it out from under the
distribution disk carefully.
If you forget to place the
collector ring, water comes
out of the lid of the machine
instead of passing through
the pod.
Switch off the coffee
machine. Pull up the lever
and wait 24 hours before
you open the lid. You may
need to use some force.
Always make sure the
pod holders are clean and
the center of the sieve is
not clogged to prevent a
vacuum.
Follow the instructions to
descale the machine.
Remove the pod holder.
Problem Possible cause
There is still water This is normal.
left in the water
reservoir after
brewing filter
coffee.
I do not get a small You have double
cup of stronger pressed the button
coffee after double too fast or you have
pressing the 1-cup waited longer than 3
or 2-cup button. seconds after pressing
the button for the first
time.
Flush before first use
Flush the machine before first use. After the flushing cycle (which only takes
approx. 2 minutes), the machine is ready for brewing coffee.
Intensity Select HD6596, HD6592
It is possible to brew even shorter stronger cups of coffee by double pressing
the 1-cup or 2-cup button.
Special coffees
To brew a special coffee, place a cappuccino pod, a hot chocolate pod or
another special coffee pod in the 2-cup pod holder and press the 1-cup
button.
Cleaning
Never use scouring pads, abrasive cleaning agents or aggressive liquids
such as petrol or acetone to clean the machine. Never rinse the inside of the
machine with the lid open. All detachable parts except for the water
reservoir and the insulated jug are dishwasher-proof.
2x descaling, 2x flushing
Descale the machine when the CALC light starts flashing. Use liquid Senseo
descaler only. The descaling procedure consists of two descaling cycles and
two flushing cycles. Each cycle lasts 5 minutes. For each descaling cycle, you
have to pour half a bottle of descaling liquid into the water reservoir and fill it
up with fresh water. Use the 1-cup pod holder with a used pod or the thin
descaling filter during the first descaling cycle and use the 2-cup pod holder
with a used pod or the thick descaling filter during the second descaling
cycle. Do not interrupt the descaling cycles and do not switch off the
machine before you have performed the two flushing cycles. The CALC light
continues to flash until the descaling procedure is completed correctly.
Throw used pods or descaling filters away after use. For more information on
why it is important to descale, when to descale and how to descale or which
descaler to use, visit our website at www.philips.com/descale-senseo.
DEUTSCH
Einführung
Herzlichen Glückwunsch zu Ihrem Kauf und willkommen bei Philips!
Um die Unterstützung von Philips optimal nutzen zu können, sollten Sie
Ihr Produkt unter www.philips.com/welcome registrieren.
Sauberes kaltes Wasser
Verwenden Sie täglich sauberes kaltes Wasser. War die Maschine über 1 Tag
nicht in Gebrauch, lassen Sie vor dem nächsten Aufbrühen sauberes kaltes
Wasser durchlaufen. Um die Maschine durchzuspülen, füllen Sie den
Wassertank mit sauberem kaltem Wasser, stellen Sie eine Schüssel oder
zwei Tassen unter den Auslauf, und drücken Sie mehrmals die 2-Tassen-
Taste, damit heißes Wasser durchläuft, bis der Wassertank leer ist.

Wichtige Sicherheitsinformationen

Lesen Sie diese Bedienungsanleitung vor dem Gebrauch der Maschine
aufmerksam durch, und bewahren Sie sie für eine spätere Verwendung auf.
Gefahr
- Tauchen Sie die Maschine niemals in Wasser
oder andere Flüssigkeiten.
Solution
The filter coffee brewing
process does not use up
all the water in the water
reservoir. This is normal.
You can get a stronger
coffee if you double press
the 1-cup or 2-cup button
within 3 seconds. The light
in the button shines less
bright when the selection of
stronger coffee is successful.