Cleaning; When The Appliance Is Not In Use; How To Change The Bulb - Küppersbusch IKE 150-2 Gebrauchs- Und Montageanleitung

GB
The most typical case of clogging up in the defrost
water outlet when you put food wrapped in some
paper into the appliance and this paper contacts back
plate of fresh food compartment and freezes to it. If
you remove the food right at this moment the paper
will tear and it can cause clogging up in the outlet by
getting into it. So you are asked to be careful -
because of the above - when placing foods wrapped
in paper into the appliance.
In case of increased demand e.g. during
heatwaves, the refrigerator temporarily happens
to operate constantly. During this the automatic
defrosting is ineffective.
Remaining small ice and frost stains on back plate of
the fresh food compartment after defrosting period is
not abnormal.
The frozen food compartment can not be equipped
with automatic defrosting set since the deep-frozen
and frozen foods do not endure melting temperature.
Provided it is not too thick, the layer of frost or ice can
be scraped off and removed using a plastic scraper.
When ice coating is so thick that it can not be removed
with the plastic scraper, the frozen food compartment
has to be defrosted (generally 2-3 times a year).
Take the foods out of the frozen and fresh food
compartment, wrap them into some layers of paper or
cloth. Put them to a possible cool place while
defrosting.
Break the circuit of the appliance and leave the doors
of frozen and fresh food compartment open.
Continuously blot off the defrosting water by a soft
cloth or sponge.
After defrosting wipe the surfaces, apply voltage to the
appliance and put the foods back to their places.
It is recommended to operate the appliance at the
highest position of the thermostatic control so that it
can reach the proper storing temperature as soon as
possible.

Cleaning

Never use metal objects for cleaning your
appliance as it may get damaged.
NEVER use detergents, abrasive powders, highly
perfumed cleaning products or wax polishes to
clean the interior as these will damage the
surface and leave a strong odour.
Clean the inside with warm water and bicarbonate of
soda. Rinse and dry thoroughly.
To guarantee a safe operation of the fridge, once a
year remove the ventilation grill at the base and clean
the air channels with a vacuum cleaner.
22
Downloaded from Fridge-Manual.com Manuals
All manuals and user guides at all-guides.com

When the appliance is not in use

Disconnect the appliance from the electricity
supply.
Empty all foods and clean the appliance, leaving
the doors ajar to prevent unpleasant smells.

How to change the bulb

Should the light fail to work you can change it as
below:
Break the circuit of the appliance.
Unscrew the plate screw fixing the lamp cover, then
take the lamp cover off in the direction of arrow and
the bulb can be changed. (Type of the bulb:
Mignon 322, 230 V, 15 W, E 14 thread)
After changing bulb replace the lamp cover, screw
the plate screw and apply voltage to the appliance.
The lack of light does not influence operation of the
refrigerator.