Cabletech URZ0922 Bedienungsanleitung Seite 20

6. When using for the first time, user needs to register (press "Register" and follow
on-screen instructions and input necessary data).
7. Open "Device Management" > "Devices", then press "+" icon, and when the list is
up, press the "+" icon again. You will see configuration interface. Enter Device ID
into "Device UID" space, and password into "Password" space. Note: Device ID
and password necessary to connect to the camera can be found on IE configuration
page (see point 1) OR press [-] icon to open code reader and scan QR code on the
IE configuration page („Setup" > „Network" > „P2P").
8. Press save icon to save changes.
IMS300 APP MANAGEMENT (for devices running Windows)
1. Install IMS300 app. Application installation file is on the CD included in the set.
2. Once the installation is complete, user will be able to access the camera from the
app.
FORGOTTEN PASSWORD
In case of forgotten password, use the reset button on the cable from the camera. Press
the button, and the device will restore factory settings (password will be reset to default).
EN
TROUBLESHOOTING
1. No picture after providing power
• Check the power supply voltage
• Check the proper connection of all the cables
2. Picture interference
• Check the monitor and peripheral equipment used
• Check the proper connection of all the cables
20
Owner's manual