Inhaltsverzeichnis
Werbung
TIGHT-TUNE BRIDGE
The Tight-Tune bridge achieves the optimum level of stability and sound transference while suppressing
unnecessary vibrations by allowing each movable part of the bridge to be locked. The bridge has a stud
lock function for fi xing the bridge more securely onto the body. Furthermore, the tailpiece is equipped
with a ball-end lock function to retain the ball end so that it will not come off.
Adjusting the action
Loosen the locking nuts (D) on the right and left sides of the bridge
unit, and adjust the height of the bridge unit by turning the stud
lock screws (E) with a 3 mm Allen wrench. Note that it is not
possible to adjust the height of individual strings. After completing
the adjustment, tighten the locking nuts.
Stud lock function
After adjusting the action, turn the stud lock bolt (B) clockwise
inside the stud bolt with a 2 mm Allen wrench. Keep tightening
until the stud lock bolt contacts the anchor bolt (C) and the bolt
cannot be turned any further.
Memo
When adjusting the action, be sure to fully loosen the stud
lock bolt (B) beforehand by turning it counterclockwise with a
2 mm Allen wrench. Otherwise, damage may occur.
ADJUSTING THE INTONATION
Loosen the saddle lock screws (G) with a Phillips screwdriver,
and turn the intonation adjustment screw (H) with a Phillips
screwdriver to adjust the saddle position. Tune the guitar and
check the intonation. Repeat these adjustments until the required
intonation is reached, and then tighten the saddle lock screws.
Memo
A loose intonation adjustment screw (H) may cause
resonance. If this occurs, gently tighten the intonation
adjustment screw, exercising care not to allow the saddle to
move.
Replacing the strings
Insert the ball-end of the string into the slot of the tailpiece in the
direction shown by arrow (J). The ball-end lock function retains the
ball-end. To remove the string, pull it toward direction (K).
All manuals and user guides at all-guides.com
A
B
F
G
E
D
H
K
J
➤➤
C
EN
61
Werbung
Inhaltsverzeichnis
