Ibanez Prestige-Serie Bedienungsanleitung Seite 51

Tremolo angle adjustment / Zero point system adjustment
The tremolo attachment angle is adjusted by changing the
balance between the string tension and the tension of the zero
point system installed on the back of the guitar body.
The Edge-Zero/ZR2 tremolo bridge is designed so that the
tremolo will be approximately parallel with the surface of the
guitar body when the zero point system is adjusted correctly, and
will perform optimally in this state.
When the zero point system is correctly adjusted, the stop rod will
be in fi rm contact with the tremolo block and the stop rod will be
touching the stopper.
1.
With the guitar tuned correctly, check the zero point system.
2.
If the stop rod is not touching the stopper (i.e., if the
tremolo block is pushing up the stop rod), turn the spring
adjustment knob located on the back of the body toward
the "plus" direction to tighten the main spring.
3.
If the tremolo block is not in fi rm contact with the stop rod
(i.e., if the tremolo is tilted toward the rear), turn the spring
adjustment knob toward the "minus" direction to loosen the
main spring.
Disabling the zero point system
(Using the unit as a conventional fl oating tremolo)
By disabling the zero point system you can also use the unit as a
conventional fl oating tremolo bridge.
When the zero point system is disabled, the angle at which the
tremolo is attached will be adjusted by the balance between
the tension of the strings and the tension of the main springs
attached to the tremolo block.
For optimal performance, adjust the tremolo so that it is
approximately parallel with the surface of the guitar body.
1.
While holding the arm in the upward position (i.e., with
the tremolo block away from the stop rod), remove the
stop rod and the sub-spring.
2.
With the guitar tuned correctly, check the angle of the
tremolo.
3.
If the tremolo is tilted toward the front, turn the spring
adjustment knob toward the "plus" direction to tighten
the main spring.
4.
If the tremolo is tilted toward the rear, turn the spring
adjustment knob toward the "minus" direction to loosen
the main spring.
※
The tuning will be affected when you adjust the tremolo angle with
the zero point system disabled, because the balance between
the tension of the strings and the springs will change each time
you adjust the tension of the tremolo springs. You'll need to tune
repeatedly while making this adjustment.
52
All manuals and user guides at all-guides.com