Fine Tuning - Ibanez Prestige-Serie Bedienungsanleitung

Replacing the strings
1.
Use an Allen wrench (3 mm) to loosen the pressure pad
bolts of the locking nut, and remove the string from the
tuning peg.
2.
Use an Allen wrench (3 mm) to loosen the string
stopper bolt of the tremolo unit; then pull the string
out of the saddle and remove it.
3.
Use wire cutters to cut off the ball end of the new
string.
4.
Insert the tip of the string from which you cut off the ball
end between the saddle and the string holder block, and
tighten the string stopper bolt to fasten the string.
5.
Wind the string onto the tuning peg, and tune it.
6.
When you've fi nished tuning, tighten the pressure pad
bolts of the locking nut.
※ Removing all strings at the same time will cause the tremolo attachment angle to change signifi cantly, so we
recommend that you replace the strings one at a time. If you remove all strings at the same time, tuning will
be easier if you wedge a piece of cloth below the tremolo to secure it so that the tremolo attachment angle
won't change signifi cantly.
Memo
• Before you tune, make sure that the string stopper bolts are fi rmly tightened.

Fine tuning

Even after you've used the locking nuts to lock the strings,
you can use the fi ne tuners to fi ne-tune each string.
The range of adjustment after the strings are locked will be
widest if you leave all fi ne-tuning bolts near the center of
their adjustable range before you tune.
46
All manuals and user guides at all-guides.com
EDGE Lo-Pro EDGE
EDGE Lo-Pro EDGE