Philips HQ 7890CC Bedienungsanleitung Seite 11

using the Jet Clean system
1 Place the shaver in the holder and completely push down the lever
to lock the shaver into place.
The charging light on the Jet Clean system flashes to indicate that
,
the shaver is being charged.
2 Press the start button to start the cleaning program. (Fig. 19)
The cleaning light starts flashing and the shaver is automatically lowered
into the cleaning fluid.
During the cleaning program, which takes approx. 1 hour, the
,
cleaning light flashes continuously.
During the first phase of the cleaning program, the shaver
,
automatically switches on and off several times and is put in
different positions.
During the second phase of the cleaning program, the shaver is
,
placed in the drying position. It stays in this position until the end
of the program. The cleaning light lights up continuously.
After the cleaning program, the shaver automatically returns to its
,
starting position and starts charging. The charging light on the Jet
Clean system flashes.
Note: If you press the start button or open the lever during cleaning, the
cleaning program is aborted and reset. In this case, the cleaning light stops
flashing and the holder returns to its starting position.
Note: If the adapter is removed from the wall socket during cleaning, the
cleaning program is aborted. The holder remains in its current position. When
the adapter is put back into the wall socket, the holder moves to the highest
position.
Note: If the fluid volume in the cleaning chamber drops below the minimum
level during the cleaning program, the program is aborted. The cleaning
light flashes with intervals and the holder returns to its starting position.
Cleaning the Jet Clean system
The cleaning chamber is not dishwasher-proof.
Clean the cleaning chamber every two weeks.
EnglisH
11