Bluetooth ® Pairing - Hama 00177057 Bedienungsanleitung

5.1. Bluetooth
Note – Pairing
• Make sure that your Bluetooth
and Bluetooth
• For more information, please refer to the operating instructions of
your terminal device.
• The earphones and the terminal device should be no further than 1
metre apart. The smaller the distance, the better.
• Make sure that the earphones are switched off.
• Device off: To activate the earphones, remove them from the
charging box at the same time and place them back in the charging
box. The status LEDs of the earphones (5) are lit red. Remove
the earphones once again. They now switch on automatically, a
voice says, 'Power on' and the status LEDs (5) flash blue. After
about 5 seconds, pairing begins and the two earphones connect to
one another. As soon as one of the two status LEDs (5) begins to
emit flashes of alternating red and blue light, your earphones are
ready to be connected to your smartphone. A voice says, 'Pairing'.
The earphones are searching for a Bluetooth
• Open the Bluetooth
until Hama Style appears in the list of Bluetooth
• Bluetooth
devices found.
®
• Select Hama Style and wait until the earphones are listed as
connected in the Bluetooth
voice says, 'Connected'.
Note – Bluetooth
If your terminal device requests a password to establish the
connection, enter 0000.
Note
If pairing was successful, the status LEDs of the earphones (5)
slowly flash blue. A voice says, 'Connected'.
• You can now use the earphones.
5.2. Automatic Bluetooth
(after successful pairing)
Note
• Make sure that your Bluetooth
and Bluetooth
• For more information, please refer to the operating instructions of
your terminal device.
pairing
®
is activated.
®
settings on your terminal device and wait
®
®
password
®
®
is activated.
®
-capable terminal device is on
®
settings on your terminal device. A
connection
-capable terminal device is on
®
connection.
®
devices found.
®
5