Mounting The Wall Holder; Using The Appliance; Charging The Built-In Battery; Maintenance And Cleaning - Clatronic AKS 828 Bedienungsanleitung

Mounting the Wall Holder

Inserting the Plug of the Power Supply Unit
(The plug is pre-assembled on delivery)
If you want to use the wall holder also as the charging
station, attach the plug of the power supply unit first. Refer
to the illustrations (A and B).
1. Set the plug of the power supply unit with the flattened
sides into the wall holder. (Fig. A)
2. Turn the plug of the power supply unit at the metal end
by 90 °. If necessary, use pliers to help. The plug must
be firmly seated in the holder and must not be able to be
moved. (Fig. B)
3. Fix the cable in the cable guide.
Fastening the Wall Holder
Mount the charging station near a power socket.
1. Measure the distance between the drill holes on the back
of the wall holder. Mark 2 drill holes.
2. Drill the holes and insert the plugs into the wall.
3. Insert the screws through the holes of the wall holder.
4. Tighten the screws with a screwdriver hand-tight into the
wall plugs.

Charging the Built-in Battery

1. Switch off the appliance.
2. Connect the power supply unit to the connection socket.
If you have prepared the wall holder as a charging sta-
tion, hang the appliance in it.
3. Connect the power supply unit to an approved power
outlet. Charge the appliance for 16 hours before using it
for the first time.
- The indicator light lights up red during charging.
- The light gives no indication of the battery's charge
status.
- It is normal for the appliance to heat up during
charging.
4. Stop all other charging process after a maximum of
12 hours or once the indicator light lights up permanently
green.
8
AKS828_IM_04.2023
CAUTION:
Always disconnect the mains plug from the socket after
charging.

Using the Appliance

1. Disconnect the appliance from the power supply unit.
2. Attach a nozzle if necessary.
3. Switch on the appliance with the switch.
Vacuuming Dry Dirt
• Only vacuum up dry dirt with a dry collection container
and a dry filter!
• The crevice nozzle with or without brush attachment is
suitable for vacuuming dry dirt.
Picking up Wet Dirt or Liquids
1. Empty the collection container before vacuuming liquids
or wet dirt.
2. Fit the attachment for wet vacuuming or the crevice
nozzle.
3. Note the MAX marking on the collection container. The
maximum collection amount is 80 ml.
4. If you want to remove the nozzle, hold the end of the
nozzle down. In this way you avoid unintentional leakage
of the liquid.
End of Use
1. Switch off the appliance.
2. Empty the collection container as described below. Clean
the filter insert after each use to restore the appliance to
full performance the next time it is used.
3. Then recharge the accumulator of the appliance.

Maintenance and Cleaning

WARNING:
• Always disconnect the appliance from the power sup-
ply unit before maintenance and cleaning!
• Never immerse the motor housing in water for clean-
ing. It could cause an electric shock or fire.
CAUTION:
• Do not use a wire brush or other abrasive objects.
• Do not use sharp or abrasive cleaning agents.
• The individual components are not suitable for clean-
ing in the dishwasher.
• Never wash the filter in the washing machine.
• The housing can be wiped clean with a slightly damp
cloth.
• You can wipe the power supply unit with a dry cloth.
19.04.23