brennenstuhl 1171620010 Bedienungsanleitung Seite 7

Operating instructions
D
Mobile rechargeable LED floodlight
with Bluetooth speaker
BLUMO 3000 A
SAFETY INFORMATION
• Carefully read these operating instructions before using the device.
• Do not use the light if it is damaged - danger of death.
In this case, contact an electrician or refer to the specified service address.
• Do not look directly into the light.
• Never open the device.
• The light is protected against spray water. Do not immerse the light in water or any other
liquids. Risk of explosion and fire!
• Keep the working light out of the reach of children. Children are not aware of the risks imposed
by electric current.
• Do not use the working light in potentially explosive atmospheres - risk of death!
• To charge the batteries, only use the provided power supply unit.
• Please note that the product is only IP54-compliant (dust-protected and protected against
splashing water) if the battery pack has been correctly inserted.
The product is not IP54-compliant (dust-protected and protected against splashing water)
– during the charging process
– during the use of the USB output.
SETTING UP/ATTACHMENT OF THE LIGHT
The tilting angle of the light can be adjusted as necessary by means of the folding bracket. To do
so, loosen the winged screws and retighten them after adjustment.
The light can be mounted on a Brennenstuhl tripod (not included in the scope of delivery).
SWITCHING THE LIGHT ON/OFF
Use the ON/OFF switch (A) to switch the light on. The light is now lit with 100 % brightness. Press
the switch twice to set the brightness to 50 % and then 10 %. This way, the lighting duration is
respectively extended. To switch off the device, press the ON/OFF switch (A) again.
BLUETOOTH SPEAKER
To use the speaker via Bluetooth, press the Bluetooth switch (B) with the Bluetooth symbol on the
back of the device: the blue LED over the Bluetooth switch (B) lights up.
Switch on the Bluetooth function on the smartphone: the light is displayed under "HB Blumo 2" in
the selection list. Afterwards, activate HB Blumo 2 on the smartphone: There is an acoustic indica-
tion by the light in the form of a signal tone.
Any music on the smartphone can now be played via the speaker of the light. The volume is con-
trolled via the smartphone.
To terminate the connection, deactivate "HB Blumo 2" on the smartphone: The light indicates it
acoustically, in the form of a signal tone. The connection can also be terminated by switching off
the Bluetooth function via the Bluetooth switch of the light (without acoustic signal).
Mobiler Akku LED Strahler Blumo 3000A 0532162 200211.indd 7
7
11.02.2020 12:00:13