Inhaltsverzeichnis
Werbung
Power cable safety
Only use rubber-sheathed cables with quality
H05RN-F acc. to DIN/VDE 0282 with a conductor
cross section of 3 phases of 1.5 mm² each.
The type designation must be marked on the power
cable. The plug and coupling socket must be made
from rubber or sheathed in rubber, and be in ac-
cordance with DIN/VDE 0620.
Only use a power cable with suffi cient length.
The power cable, plug and coupling socket must be
protected against splash water.
Repairs on the power cable, plug and coupling
socket are only allowed to be carried out by author-
ised specialist companies. A defective power cable
(e.g. with cracks, cuts, crushed or kinked points in
the insulation) is not allowed to be used.
Protect the plug connections against moisture.
Danger!
Do not damage or cut the power cable.
If the power cable is damaged, immediately discon-
nect it from the mains.
Electrical requirements
230 V/50 Hz alternating current
Minimum cross section
Power cable = 1.5 mm²
Minimum fusing of mains connection = 10 A
Residual-current circuit breaker (RCCB)
Maximum tripping current = 30 mA.
Establishing the mains connection (05)
1. Connect the coupling part of the power cable to the
plug on the safety pushbutton switch (a).
2. Coil the power cable into a loop and hook it into the
cable strain relief (b). Leave the loop long enough
for the cable strain relief to be able to slide from
one side to the other.
Danger!
Never operate the machine from mains sockets which
do not have a residual-current circuit breaker.
441820_d
Setting the working depth (04)
Important!
Only set the working depth if the engine is switched
off and the blade shaft is stopped.
Set the working depth of the blade shaft at the dial se-
lector.
1. Tilt the scarifi er backwards with the handlebar.
2. Push the twist switch down and turn it to level "1".
Positions on the dial selector:
1 - 5 = Setting the working depth (04)
With new blades, set the dial selector to position
2 at most!
The correct working depth depends on:
the condition of the lawn
the wear on the blades
If the working depth is set too low:
the scarifi er will stop
the engine will stall
In this case, move the dial selector back to a shallower
working depth.
Always mow the lawn before scarifying.
Starting the engine (06)
1. Push and hold the button of the safety pushbutton
switch (a).
2. Pull the operator presence control against the
handlebar (b). The motor starts.
The operator presence control does not lock in
The operator presence control does not lock in
place. It must be held in place all the time.
place. It must be held in place all the time.
3. Release the button of the safety pushbutton switch.
Switching off the motor (07)
1. Release the operator presence control (a). It auto-
matically returns to its initial position. The motor is
switched off.
Danger of lacerations!
The blade shaft keeps turning under its own mo-
mentum! After switching off, do not reach under
the machine straight away.
GB
17
Werbung
Inhaltsverzeichnis
