Werbung
Verfügbare Sprachen
Verfügbare Sprachen
All manuals and user guides at all-guides.com
UK
NOVA 10 CAS
WARNING
•
Always respect applicable legislation for working with electrical equipment in order to reduce the risk of accidents.
•
Avoid looking directly into the beam of light, as this will result in dazzling.
•
Do not use the lamp near a naked flame.
•
Protect the mains cable from oil, heat and sharp edges.
•
Only use Metabo CAS battery packs. Internal backup battery must be replaced with an original SCANGRIP battery.
•
Do not leave the battery flat, as this could render it INCAPABLE of being charged again.
•
The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire
shall be replaced
•
Luminaire is only suitable for direct mounting on non-combustible surfaces.
•
The luminaire is designed to work with all Metabo CAS battery packs.
•
If the lamp is disconnected from mains and the battery is discharged, push the power button to enable internal back
up battery. 10% LED will blink to indicate back up mode.
THE PROCESS TO DELETE THE PIN CODE IS:
•
Turn on the Bluetooth function.
•
Press the Bluetooth button for 10 second.
•
The pin code is reset.
INTEGRATED BLUETOOTH LIGHT CONTROL
•
Turn lamp on/off or adjust lamp output.
•
Connect, up to 4 lamps together.
•
Assign a pincode to prevent other users from controlling the lamp.
Compliant with iPhone 5 or higher and Android 5.0 or higher.
Go to iTunes App Store, Google Play or download the app from our website.
USE:
•
To turn the lamp on or off, press the A button.
•
To increase the brightness, press the B button.
•
To decrease the brightness, press the C button.
•
When the brightness level is changed, the new value is saved,
and the lamp will start at that level the next time it is turned on.
•
To enable/disable Bluetooth, press the button.
THE LAMP HAS THREE DIFFERENT IP RATINGS DEPENDING ON THE USE:
•
IP65 when used with a Scangrip power supply.
•
IP54 When the battery cover is mounted and closed.
•
IP30 When the battery cover is removed and the Scangrip power supply is not used.
BATTERY COMPLIANCE:
•
The work light is designed to be used with Metabo CAS batteries.
•
It will accept the following battery voltages; 12V and 18V.
•
It is possible to use a Scangrip power supply instead of a battery.
•
When using a Scangrip Power Supply the battery cover must be removed.
USB POWER OUTLET
•
Built-in USB power outlet to charge mobile devices.
•
Output: 5V, 1A
•
The USB outlet is disabled when the lamp is in backup mode.
The power bank will automatically shut down when the battery pack is discharged or removed. When using the power bank
while the power supply is connected, the luminous output will be reduced to 75%.
Discarded electrical products must not be disposed of together with household waste. Please
use recycling facilities. Ask your local authority or retailer for advice on recycling.
- The battery must be removed from the device before it is broken up
- The device must be disconnected from the mains when the battery is removed
- Please dispose of the battery safely
WARNING - RISK OF FIRE:
Minimum distance from lighted objects 0.1m
B
D
C
0.1
m
A
Werbung
