Nibe UKV 500 Benutzer- Und Installateurhandbuch Seite 18

REMOVING THE INSULATION
The insulation can be removed to facilitate handling in
confined spaces.
(The diameter without insulation for UKV 500 is Ø 662
mm).
• Lift off the top cover and remove the insulation at the
top.
• Remove all screws along the joining plate.
• Remove the insulated jacket.
• Remove the four insulated jacket sections.
The figure shows removal of insulation on UKV 500
When the accumulator tank has been placed in the cor-
rect location, reinstall the removed components in the
reverse order.
Finally, fit all the supplied cover discs on the relevant
connections by pressing them over the connections.
Caution
Fit the cover discs before the pipe installation
is made.
18 UKV 500 | GB