Bosch PHD 5962 Gebrauchsanleitung Seite 10

en
Congratulations on purchasing this
Bosch appliance.
You have acquired a high-quality
product that will bring you a lot of enjoy-
ment.
Controls and accessories
1 Temperature slide switch
õ
= low
ô
= medium
k
= high
2 Fan slide switch
— = off
ó
= gentle
l
= strong
3 Ionisation switch ion
4 Ionisation LED light strip
5 Lockable Cool button
6 Air inlet grill (removable)
7 Diffuser
8 Styling nozzle
9 Hanging eyelet
Use
The blow and temperature settings can be
freely combined.
General
■ Never cover the blower or air inlet.
■ Make sure the air inlet is free of lint and
hair.
■ The hairdryer will switch off automatically
if it overheats due to the air inlet being
covered. It will switch back on automati-
cally after a few minutes.
Important: Be sure to unplug the appliance
and wait a few minutes until it has cooled
down. It can then be used as before.
■ To pre-dry wet hair, select the higher
l
setting . Hold the appliance about
10 cm away from your head.
8
k
l
3
Ionisation
This hair dryer features ionisation technol-
ogy. Ions are electrically loaded particles
that exist in the air, which are created by an
ion generator in the hair dryer.
These make the hair softer and easier
to comb. The static charge in the hair
which causes "fly-away" hair is reduced
(= a nti-static effect).
The ionisation function can be switched on
and off by means of switch 3. The LED strip
light lights up red as soon as the ionisation
is switched on.
Cool button
The Cool function is ideal for ‚setting' the
hair after drying. It fixes the individual hair
sections with the cool airflow.
Press the Cool button
c ooling function in any setting.
Press the Cool button
the cooling function.
Diffuser
The diffuser 7 is ideal for straight or
damaged hair. It gives fine, long or medi-
um-length hair more volume.
Hold the tips of the diffuser upwards, tilt
your head sideways and run the diffuser
into your hair from below, lifting it up. The
hair should rest gently between the individ-
ual fingers of the diffuser while drying.
Use:
■ Set the fan and temperature to a low
setting.
■ To 'set' the volume and natural curls,
press the Cool button
■ Repeat the process with individual
s ections of hair.
Warning! The styling nozzle 8 and
d iffuser 7 can become hot. Allow them to
cool down before detaching.
3
3
to activate the
3
again to switch off
3
.