Bosch DKE 685 C Gebrauchs- Und Montageanleitung Seite 22

Setting the saturation indicator
If it becomes necessary to change the
operating mode (exhaust-air/recirculating
mode), the saturation indicator for the filters
must also be altered (see Installation
Instructions).
22
All manuals and user guides at all-guides.com
If you encounter a problem
If an
If is not possible to operate the extractor
hood:
If you have any questions or if a fault
occurs, please call Customer Service.
(See list of Customer Service
representatives).
When you call, please quote the following:
Enter the relevant numbers into the box
above. The E-Nr. (product no.) and FD
(production date) are shown on the
nameplate which can be seen inside the
extractor hood after the filter frame has
been detached.
or appears in the display:
# ã
See "Filters and maintenance" Section.
Disconnect the extractor hood from the
mains electricity supply by pulling out the
plug or switching it off at the main fuse
box.
Wait for approx. 1 minute and then
switch it on again.
E-Nr. FD