Lock Key; Open Windows Function - Termat MTPCR500T Installationsanleitung Und Gebrauchsanleitung

• On top of the display, the message "Set" is displayed.
•
• Press [Prog] button to enter edit mode.
•
• Press the [+] and [-] buttons to select the correct day.
•
• You must conclude the previous stages, the procedure to select the time
starts and the display shows the current time.
• Use the [+] and [-] buttons to set the correct time.
•
• The same procedure used to modify the time is used to modify the mi-
nutes.
•
• At the end of this procedure, thermostat will return to "Stand-by" mode.
• Go into "Stand-by" mode and press [-] at least for 3 seconds.
• On top of the display, the "Set" message is displayed.
• To establish the day and time, press [+] button until "Prog" message appears on the upper side
• Press [Prog] button to enter edit mode.
• Now you can set a time interval for each day of the week.
•
buttons for each hour of the day, it is possible to asigne for each hour the temperature mode
•
remaining 6 days of the week.
It allows the detection of an open window if a sharp decrease in temperature is detected in the room.
in the room temperature reveals that the window has closed.
To activate this function:
• Enter "Stand-by" mode.
• Press the [+] button for 3 seconds.
• Press the [+] button to enable or disable the function.
• Press the [Prog] button to return to the "Stand-by" mode.
When this function is activated, the "Open window" icon on the screen lights up. When the device
is deactivated, the "Open window" icon does not illuminate on the screen. The device could fail to
temperature in the room is too slow.
lock icon is activated on the screen.
To unlock press the [Prog] button again for 3 seconds. The keypad lock
icon disappears on the screen.
K.
INSTALLATION AND USER MANUAL
9
EN